Panasonic commercial LED lighting shipments exceeded one million units

Panasonic issued a press release on the 12th to announce that due to the promotion of energy-saving policies by Japanese companies and the introduction of LED lighting products, the lighting subsidiary "Panasonic Corporation Eco Solutions Company (hereinafter referred to as PCESC)" manufactures/sells commercial (office/factory) The LED lighting products "Integrated LED Basic Light iD Series" has exceeded 1 million units in Japan, and this milestone has been achieved in less than one year since it was launched in December 2012. The time to ship a million units was nearly four months earlier than the end of March 2014, which was originally estimated by Panasonic.

Like the fluorescent light, the iD series can be replaced by removing the LED from the lighting fixture, so the brightness and light color can be easily changed. Panasonic plans to launch it in February 2014. As long as no one is sensing, it will automatically lower. New product for brightness.

It is reported that in Panasonic's overall commercial lighting products, LED lighting products accounted for about 45% of the standard.

Single Notching

The single groove blanking process of motor blanking is a kind of blanking process relative to double blanking. Motor fixed, Rotor Core punching using single groove punching process, its mold design, manufacturing are relatively simple, suitable for small batch, variety of production, has the characteristics of low cost, fast change. With the development of advanced punching machine, production efficiency continues to improve, the single punching process is also developing rapidly. For the large motor, because of the cost of the duplex die and the equipment capacity, the single groove is also used. Another advantage of single groove punching is the consistency of groove size. Compound die is the same punch, stator or rotor groove completed at one time. How many slots correspond to the same number of punches, punch size to achieve complete has always been some difficulties: single slot punching is by the same punch to complete all the slots, groove consistency is better.
Stator and rotor laminations are an important part of motors and generators. For large-size and small-batch punching sheets, we usually use the notching method to produce them. The advantages of notching are that the cost of the notching die is low and the production cycle of the notching die is short. It is suitable for producing large size laminations, usually the outer diameter is from 500mm-1250mm. The slot size is more accurate than Laser Cutting.

Stator And Rotor Lamination By Single Notching,Stator Core Laminations,Generator Stator Laminations,Electric Motor Rotor Laminations

Henan Yongrong Power Co., Ltd , https://www.hnyongrongglobal.com

Posted on