Antistatic load tester
This part specifies the static load puncture test of asphalt and polymer roofing waterproofing membrane. The long-term static load on the coil is different from the mechanical stress of short-time dynamic load. This method represents the static type with a certain time. pressure.
Antistatic load tester is suitable for
GB/T328.1
Building waterproofing membrane test method
1
Part: Asphalt and polymer waterproofing membrane
Sampling rule
Instructions:
1
The test piece is fixed on the frame with nails and placed directly on the support. The inner dimensions of the frame are approximately
500mmX500mm
. The support is expanded polystyrene (
20
±
2
)kg
/m
3
,
thickness(50
±
1
)
Mm
. Specimen size
550mmX550mm
±
2 mm
, in addition to the entire width of the coil
100 mm
Sampling, each load condition should be taken
3
Test pieces.
2
Test at (
twenty three
±
2
)
°C
get on. For all tests for each load interval, a new test piece should be used with the test piece placed on the horizontal support with the upper surface facing up. The puncture tool is placed in the center of the test piece.
3
Test from
5
Each load interval starting from kg is tested in parallel with three test pieces, and the load is increased each time.
5
Kg until the puncture occurs, or until the maximum load20
Kg, the load process for each load interval is24h.
Do not carry the load carefully, do not vibrate.4
The static load resistance is tested in three parallel test pieces according to the specified method, and all three pass through the flexible roofing membrane or waterproof material without leakage at the required load.
Recommend Vape,Disposable Vape,Electronic Cigarette,Puff Bar Disposable Vape
Guangzhou Yunge Tianhong Electronic Technology Co., Ltd , https://www.e-cigarettesfactory.com